6. UniSens-E 140A / XT90 Serial

UniSens-E 140A / XT90 Serial

Your Price: $84.90
PN: SM3109
Status: IN STOCK


If you are looking for the most versatile telemetry module for electric-powered models look no further as the UniSens-E does it all!

This Unisense-E version enables you to connect two batteries with an XT-90 connector in serial. For example, two 6S LiPo batteries will be combined into a 12S pack.

The UniSens-E telemetry module is not only compact and easy to setup and install, but it can also measure real-time data of current, main battery voltage, power, used battery capacity, altitude, Vario of climb and sink rates, and RPM.

If your existing ESC has no telemetry capabilities, you can install the UniSens-E module and get an instant overview of how your electrical system is performing on your telemetry radio system.

The UniSens-E telemetry module is compatible with the following telemetry radio systems:

Graupner HoTT, Jet, Futaba, Spektrum, FrSky, CORE, JR and Multiplex.

Setting up the UniSens-E telemetry module can be done with either your radio or with the downloadable software where you can make all the settings, configure alarms and also update the firmware.

The UniSens-E telemetry modules supports a wide range of battery connector types that are already pre-soldered or you can make your own. 


  • Real-Time data measurement of current, voltage, power, capacity, altitude, Vario, and RPM
  • Depending on the module version currents can be measured from 55A / 140A / 280A at voltages of up to 60V
  • Integrated RPM sensor for brushless motors (not on the 55A version)
  • Altitude measurement of up to 8000 meters (26000 feet)
  • Barometric sensor for accurate Vario detection of climb or sink rates
  • Optional control channel for remote activation of additional functions
  • Connection interface for the optional UniDisplay module
  • Compatible with Graupner HoTT, Jet, Futaba, Spektrum, FrSky, CORE, JR and Multiplex
  • Free downloadable software for setting up the module and alarms (can also be done from the radio).
  • Can be used in combination with the GPS Logger 3 for flight data recording on the memory card.


  • UniSens-E sensor
  • Connector cables for telemetry
  • Connector wire for RPM measurement
  • Downloadable English Manual
  • Downloadable English Setup Software
  • Made in Germany


The UniSens-E is preset for Graupner HoTT telemetry. Changing to your radio system is easily done using your radio and receiver over a free channel. You can also accomplish this by using the free downloadable PC software or with the UniDisplay product.

Related Products