Receiver Antenna 150mm

The replacement antenna is reasonably straight forward to fit. The slightly awkward step is opening the GR-12L receiver case. The two plastic tangs at the servo connector end release easily with slight inward pressure but the two tangs at the opposite end are hard against the circuit board and do not release easily. Considerable pressure is required using a small flat blade srcewdriver. Once the case is open the press stud type connector of the broken antenna can be removed with your fingers. To fit the new antenna, carefully align the press stud connector with the half on the circuit board and pree firmly into place. You will hear it click. Align the antenna grommet in the slots of the receiver case then press the case halves together. Job done!